ZyXEL NWA3000-N User Manual Page 268

  • Download
  • Add to my manuals
  • Print
  • Page
    / 386
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 267
Chapter 21 Troubleshooting
NWA3000-N Series User’s Guide
268
One of the LEDs does not behave as expected.
1 Make sure you understand the normal behavior of the LED. See Section 1.7 on
page 27.
2 Check the hardware connections. See the Quick Start Guide.
3 Inspect your cables for damage. Contact the vendor to replace any damaged
cables.
4 Disconnect and re-connect the power adaptor or PoE power injector to the
NWA3000-N series AP.
5 If the problem continues, contact the vendor.
21.3 NWA3000-N series AP Access and Login
I forgot the IP address for the NWA3000-N series AP.
1 The default IP address is 192.168.1.2.
2 Use the commands through the console port to check the IP address. Connect
your computer to the CONSOLE port using a console cable. Your computer should
have a terminal emulation communications program (such as HyperTerminal) set
to VT100 terminal emulation, no parity, 8 data bits, 1 stop bit, no flow control and
115200 bps port speed.
3 If this does not work, you have to reset the device to its factory defaults. See
Section 21.6 on page 277.
I cannot see or access the Login screen in the web configurator.
1 Make sure you are using the correct IP address.
The default IP address is 192.168.1.2.
If you changed the IP address, use the new IP address.
Page view 267
1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 385 386

Comments to this Manuals

No comments