ZyXEL NWA3000-N User Manual download pdf (Page 153)

Chapter 12 AP Profile

NWA3000-N Series User’s Guide

153

Rate Configuration This section controls the data rates permitted for clients.

For each Rate, select a rate option from its list. The rates are:

• Fast Select - Select an 802.11 broadcast frequency to determine

the baseline rate configuration.

• Basic Rate (Mbps) - Set the basic rate configuration in Mbps.

• Support Rate (Mbps) - Set the support rate configuration in

Mbps.

• MCS Rate - Set the MCS rate configuration.

WDS Settings This section displays if you set the Operating Mode to AP+Bridge

or Bridge/Repeater. Configure the security settings for the

NWA3000-N series AP’s Wireless Distribution System (WDS), the

wireless connection between two or more APs.

Select No Security to not encrypt the traffic between APs.

Note: WDS security is independent of the security settings

between the NWA3000-N series AP and any wireless

clients.

Select TKIP (ZyAIR Series Compatible) to enable Temporal Key

Integrity Protocol (TKIP) security on your WDS. This option is

compatible with other ZyXEL access points that support WDS

security. Use this if the other access points on your network support

WDS security but do not have an AES option.

Note: Check your other AP’s documentation to make sure it

supports WDS security.

Select AES to enable Advanced Encryption System (AES) security on

your WDS. AES provides superior security to TKIP. Use AES if the

other access points on your network support it for the WDS.

Note: At the time of writing, this option is compatible with other

ZyXEL NWA access points only.

When you enable WDS security, for each access point in your WDS

enter the AP’s MAC address and a pre-shared key. Each access point

can use a different pre-shared key. Configure WDS security and the

relevant PSK in each of your other access point(s).

Note: Other APs must use the same encryption method to

enable WDS security.

Edit Click this to edit the selected entry.

Activate To turn on an entry, select it and click Activate.

Inactivate To turn off an entry, select it and click Inactivate.

# This field is a sequential value, and it is not associated with a specific

user.

Status This field shows whether or not the entry is activated.

Table 53 Configuration > Object > AP Profile > Add/Edit Profile (continued)

LABEL DESCRIPTION

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 385 386

Comments to this Manuals

No comments

ZyXEL NWA3000-N User Manual Page 153

Comments to this Manuals

Related products and manuals for Routers ZyXEL NWA3000-N