ZyXEL NWA3000-N User Manual download pdf (Page 119)

Chapter 9 Wireless

NWA3000-N Series User’s Guide

119

9.5 Load Balancing

Use this screen to configure wireless network traffic load balancing between the

APs on your network. Click Configuration > Wireless > Load Balancing to

access this screen.

Figure 49 Configuration > Wireless > Load Balancing

Each field is described in the following table.

OK Click OK to save your changes back to the NWA3000-N series AP.

Cancel Click Cancel to close the window with changes unsaved.

Table 41 Configuration > Wireless > MON Mode > Add/Edit Rogue/Friendly

LABEL DESCRIPTION

Table 42 Configuration > Wireless > Load Balancing

LABEL DESCRIPTION

Enable Load

Balancing

Select this to enable load balancing on the NWA3000-N series AP.

Mode Select a mode by which load balancing is carried out.

Select By Station Number to balance network traffic based on the

number of specified stations connect to an AP.

Select By Traffic Level to balance network traffic based on the

volume generated by the stations connected to an AP.

Once the threshold is crossed (either the maximum station numbers

or with network traffic), then the AP delays association request and

authentication request packets from any new station that attempts to

make a connection. This allows the station to automatically attempt

to connect to another, less burdened AP if one is available.

Max Station

Number

Enter the threshold number of stations at which an AP begins load

balancing its connections.

Traffic Level Select the threshold traffic level at which the AP begins load balancing

its connections (low, medium, high).

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 385 386

No comments

ZyXEL NWA3000-N User Manual Page 119