ZyXEL NWA3000-N User Manual Page 247

  • Download
  • Add to my manuals
  • Print
  • Page
    / 386
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 246
Chapter 17 File Manager
NWA3000-N Series User’s Guide
247
File Name This column displays the label that identifies a configuration file.
You cannot delete the following configuration files or change their file
names.
The system-default.conf file contains the NWA3000-N series AP’s
default settings. Select this file and click Apply to reset all of the
NWA3000-N series AP settings to the factory defaults. This configuration
file is included when you upload a firmware package.
The startup-config.conf file is the configuration file that the NWA3000-
N series AP is currently using. If you make and save changes during your
management session, the changes are applied to this configuration file.
The NWA3000-N series AP applies configuration changes made in the
Web Configurator to the configuration file when you click Apply or OK. It
applies configuration changes made via commands when you use the
write command.
The lastgood.conf is the most recently used (valid) configuration file
that was saved when the device last restarted. If you upload and apply a
configuration file with an error, you can apply lastgood.conf to return to
a valid configuration.
When you change the NWA3000-N series AP’s operation mode, it backs
up the configuration to a xxx-backup.conf file where xxx denotes the
mode the NWA3000-N series AP was previously using.
Size This column displays the size (in KB) of a configuration file.
Last Modified This column displays the date and time that the individual configuration
files were last changed or saved.
Upload
Configuration
File
The bottom part of the screen allows you to upload a new or previously
saved configuration file from your computer to your NWA3000-N series
AP
You cannot upload a configuration file named system-default.conf or
lastgood.conf.
If you upload startup-config.conf, it will replace the current
configuration and immediately apply the new settings.
File Path Type in the location of the file you want to upload in this field or click
Browse ... to find it.
Browse... Click Browse... to find the .conf file you want to upload. The
configuration file must use a “.conf” filename extension. You will receive
an error message if you try to upload a fie of a different format.
Remember that you must decompress compressed (.zip) files before you
can upload them.
Upload Click Upload to begin the upload process. This process may take up to
two minutes.
Table 88 Maintenance > File Manager > Configuration File (continued)
LABEL DESCRIPTION
Page view 246
1 2 ... 242 243 244 245 246 247 248 249 250 251 252 ... 385 386

Comments to this Manuals

No comments