ZyXEL zyxel Prestige100 User Manual download pdf (Page 83)

TCP/IP Configuration 71

need to configure Static Routes if some services reside beyond the

immediate remote LAN.

Remote Node Setup

Follow the procedures in Chapter 5 to fill the protocol-independent

parameters in Menu 11, Remote Node Profile. For the protocol-

dependent parameters, follow the instructions below. If you are

configuring the Prestige to receive an incoming call, you also need

to set the default dial-in parameters in menu 13 (see Chapter 6).

1. Route - Make sure IP is among the protocols in the “Route“

field.

2. IP Address - Enter the IP address of the gateway at the remote

site (in this case, headquarters). If the remote router is using a

different IP address than the one entered here, the Prestige will

drop the call.

3. Edit IP - Press the space bar to change it to ‘Yes’ and press

Enter to go to the ‘Menu 11.3 - Remote Node Network Layer

Options’ menu shown below:

Figure 7-2 Menu 11.3 - Remote Node Network Layer Options

4. Rem IP Address - This will show the IP address you entered

for this Remote Node in the previous menu.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 129 130

No comments

ZyXEL zyxel Prestige100 User Manual Page 83