24 Installation
• Crossover cable (red tag): Connect your Prestige to your
computer directly without a hub.
:DUQLQJ:DUQLQJ ,IWKLVFDEOHLVXVHGWRFRQQHFW,6'1LWPD\GDPDJH\RXU3UHVWLJH
• AUI
The AUI port (the connector with 15 pins) is used to connect
the Prestige to a 10Base5 (thicknet) network.
If you have a 10Base2 network using BNC connectors and thin
coaxial cables, you will need a transceiver between the AUI
port and the 10Base2 cabling.
Connecting a Power Adapter to your Prestige
Plug the power adapter into the outlet on the rear panel of the
Prestige labeled ‘POWER’.
At this point, you should have connected the RS-232 cable, the
ISDN phone line, the Ethernet cable, and the power supply. You
can now power on your Prestige.
Prestige Front Panel
Names and descriptions of the Prestige front panel LED's are listed
below:
Figure 3-2 Front Panel
PWR - This LED (power) comes on as soon as you connect you
Prestige to the power supply and switch it to the ‘I’ (on) position.
TST - The TST (Test) LED should be blinking if the Prestige is
functioning properly.
Comments to this Manuals