ZyXEL zyxel Prestige100 User Manual download pdf (Page 76)

64 Dial-In Configuration

address. This is to prevent the remote host from using an

invalid IP address and potentially disrupting the whole network.

If set to No, the remote host must use the IP address assigned

by the Prestige from the IP pool, configured below. The default

is ‘Yes’.

10. Dial-In IP Address Supplied By: IP Pool - This field tells the

Prestige to provide the remote host with an IP address from the

pool. This field is required if Dial-In IP Address Supplied By:

Dial-in User is set to ‘No’. You can configure this field even if

Dial-in User is set to ‘Yes’, in which case the Prestige will

accept the IP address if the remote peer specifies one;

otherwise, an IP address is assigned from the pool. The default

is ‘No’.

11. IP Pool: IP Start Addr - This field is active only if you

selected ‘Yes’ in the Dial-In IP Address Supplied By: IP Pool

field. The IP pool contains contiguous IP addresses and this

field specifies the first one in the pool.

12. IP Count (1,2) - In this field, enter the number (1 or 2) of the

addresses in the IP Pool. For example, if the starting address is

192.168.135.5 and the count is 2, then the pool will have

192.68.135.5 and 192.68.135.6

13. Session Options: Input Filter Sets and Session Options:

Output Filter Sets - In these fields, you need to select the

filter set(s) to filter the incoming and outgoing traffic between

your Prestige and the Remote Dial-in User. Please keep in mind

that these filter set(s) will only apply to all Remote Dial-in

Users but not the Remote Nodes.

You can choose from 12 different filter sets. In addition, you

can link up to 4 filter sets together for further customization

(e.g., ‘1, 5, 9, 12’). Please note that spaces and ‘,’ are accepted

in this field. For more information on customizing your filter

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 129 130

No comments

ZyXEL zyxel Prestige100 User Manual Page 76