ZyXEL zyxel Prestige100 User Manual download pdf (Page 65)

Remote Node Configuration 53

Remote Node using the Primary Phone number first. If the

Primary Phone number is busy or does not answer, the Prestige

will call the Secondary Phone number if available. Once

connected, the Prestige will use the BACP (Bandwidth

Allocation Control Protocol) to establish the second B-channel

if Multilink PPP is enabled, and the Remote Node supports MP

and BACP.

12. Route - This fields determines the protocols that the Prestige

will route. The choices for this field are determined by the

features enabled on your Prestige.

13. Edit PPP Options - To edit the PPP options for this Remote

Node, move the cursor to this field, use the space bar to select

‘Yes’ and press ENTER. This will bring you to ‘Menu 11.2 -

Remote Node PPP Options’ For more information on

configuring PPP options, please see the section ‘Editing PPP

Options’.

14. IP Addr - This is a required field if Route is set to ‘IP’. Enter

the IP address of this Remote Node.

15. Edit IP - To edit the parameters of the protocols, go to this

field, select ‘Yes’ and press ENTER. This will bring you to

‘Menu 11.3 - Remote Node Network Layer Options. For more

information on filling out this screen, please refer to the chapter

on TCP/IP protocol.

16. Telco Options: Transfer Rate - This field (which only applies

to outgoing calls) controls the rate at which the data is

transferred between your Prestige and the Remote Node. There

are four options for this field:

• 64K - The Prestige will place 64Kbps (bits per second)

digital data calls.

• 56K - (For North America only) The Prestige will place

56Kbps digital data calls.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 129 130

No comments

ZyXEL zyxel Prestige100 User Manual Page 65