ZyXEL zyxel Prestige100 User Manual download pdf (Page 37)

Installation 25

ISDN: LNK - This LED indicates that the Prestige has an ISDN

line connected to the WAN interface and it has been successfully

initialized.

ISDN: B1 and B2 - These LEDs are on if there is an active WAN

session on that channel or if that channel is making or receiving a

call.

ETHERNET: LNK - This LED indicates that the Prestige has

been successfully connected to the LAN via a UTP Ethernet

interface.

ETHERNET: TX and RX - Transmit and Receive LEDs will blink

to indicate when there is traffic over the LAN.

ETHERNET: COL - This LED indicates that there is transmission

collision over the LAN

PHONE: 1 - This LED indicates the functionality of the POTS

port 1 on the Prestige. If there is a device plugged into this port,

and the device is in use, this LED should be on.

PHONE: 2 - This LED indicates the functionality of the POTS

port 2 on the Prestige. If there is a device plugged into this port,

and the device is in use, this LED should be on.

Powering On Your Prestige

When you power on your Prestige, the Prestige will perform

several internal tests and will also do an ISDN line initialization.

After this initialization, the Prestige will ask you to press ENTER

to continue as shown below:

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 129 130

No comments

ZyXEL zyxel Prestige100 User Manual Page 37