ZyXEL zyxel Prestige100 User Manual download pdf (Page 34)

22 Installation

the correct cable for each connection; otherwise, your Prestige

could be damaged.

Connecting Your Computer and Your Prestige

For the initial setup of your Prestige, you must use RS-232 and

communication software to configure the Prestige.

After the Prestige has been successfully installed, you can modify

the configuration through a remote Telnet connection. See Chapter

10 for detailed instructions on using Telnet to configure your

Prestige.

Connecting the RS-232 Cable to your Prestige

One 9-25 pin adapter is included in your package. To connect a

RS-232 cable, connect the 9-pin end of the cable to the DTE port

on the back panel of the Prestige. Connect the other end to the RS-

232 cable connected to the serial port (COM1, COM2, or any other

COM port) of your computer.

Connecting an ISDN Line to your Prestige

Plug one end of your ISDN phone line which is included in your

package into the socket on the rear panel of the Prestige labeled

‘ISDN’ and the other end into the ISDN wall jack.

• S/T interface - This can only connect to your NT-1 (Network

Termination) device.

:DUQLQJ:DUQLQJ 'RQRWXQGHUDQ\FLUFXPVWDQFHVFRQQHFWGLUHFWO\WRWKH,6'1ZDOOMDFN

• U interface - This allows you to connect directly to your ISDN

wall jack.

:DUQLQJ:DUQLQJ 7KH,6'1MDFNLVIRU,6'1OLQHFRQQHFWLRQRQO\&RQQHFWLRQRIDSKRQHOLQH

PD\UHVXOWLQGDPDJHWR\RXU3UHVWLJH

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 129 130

No comments

ZyXEL zyxel Prestige100 User Manual Page 34