ZyXEL NWA-3160 User Manual Page 292

  • Download
  • Add to my manuals
  • Print
  • Page
    / 372
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 291
Chapter 24 Troubleshooting
NWA-3160 Series User’s Guide
292
Disconnect and re-connect the power adaptor or cord to the NWA.
If this does not work, you have to reset the device to its factory defaults. See
Section 2.3.1 on page 36.
I cannot access the NWA via the console port.
Check to see if the NWA is connected to your computer's console port.
Check to see if the communications program is configured correctly. The
communications software should be configured as follows:
VT100 terminal emulation.
9,600 bps is the default speed on leaving the factory. Try other speeds in case
the speed has been changed.
No parity, 8 data bits, 1 stop bit, data flow set to none.
I cannot use FTP to upload / download the configuration file. / I cannot use FTP to
upload new firmware.
See the troubleshooting suggestions for I cannot see or access the Login screen in
the web configurator. Ignore the suggestions about your browser.
The Web Configurator keeps logging out.
The management session automatically times out when the time period set in
the Administrator Inactivity Timer field expires (default five minutes).
Simply log back into the NWA if this happens.
Change the time out value in the System > General screen to have more time
between automatic logouts when the Web Configurator is idle.
24.4 AP Management Modes
The primary controller AP cannot connect to the secondary controller AP.
The controllers need to have static IP addresses in the same network. Make sure
you set the IP addresses in the IP screen.
Page view 291
1 2 ... 287 288 289 290 291 292 293 294 295 296 297 ... 371 372

Comments to this Manuals

No comments