ZyXEL VSG-1200 User Manual download pdf (Page 41)

VSG-1200 V2 User’s Guide

41 Chapter 2 Hardware Installation and Connection

2.2.2 Front Panel LEDs

The following table describes the LEDs on the front panel. When turned on, all LEDs are

green unless otherwise specified.

2.2.3 Rear Panel

The power socket, the fan and a ventilation hole are located on the rear panel as shown next.

Note: Do NOT block the ventilation hole.

Figure 7 Rear Panel

2.2.4 Turning on the VSG

Connect the female end of the supplied power cord to the power socket on the back of the

VSG and the male end to an appropriate power source.

When the power source is turned on, the PWR LED on the front panel turns on.

Table 1 Front Panel LEDs

LED STATUS DESCRIPTION

PWR On The VSG is receiving power.

Off The VSG is not receiving power.

SYS On The system is functioning normally.

Blinking The system is not functioning properly.

Off The system is not ready or has failed.

LAN or WAN

10 On The port is connected at 10 Mbps.

Blinking The port is receiving or sending data.

Off The port is not connected to an Ethernet device.

100 On The port is connected at 100 Mbps.

Blinking The port is receiving or sending data.

Off The port is not connected to an Ethernet device.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 281 282

No comments

ZyXEL VSG-1200 User Manual Page 41