ZyXEL P-660HW-T1 User Manual download pdf (Page 384)

100

101

P-660H/HW/W-T Series User’ Guide

Appendix E 384

Appendix E

Boot Commands

The BootModule AT commands execute from within the router’s bootup software, when

debug mode is selected before the main router firmware is started. When you start up your

Prestige, you are given a choice to go into debug mode by pressing a key at the prompt shown

in the following screen. In debug mode you have access to a series of boot module commands,

for example ATUR (for uploading firmware) and ATLC (for uploading the configuration file).

These are already discussed in the Firmware and Configuration File Maintenance chapter.

Figure 256 Option to Enter Debug Mode

Enter ATHE to view all available Prestige boot module commands as shown in the next

screen. ATBAx allows you to change the console port speed. The x denotes the number

preceding the colon to give the console port speed following the colon in the list of numbers

that follows; for example ATBA3 will give a console port speed of 9.6 Kbps. ATSE displays

the seed that is used to generate a password to turn on the debug flag in the firmware. The

ATSH command shows product related information such as boot module version, vendor

name, product model, RAS code revision, etc. ATGO allows you to continue booting the

system. Most other commands aid in advanced troubleshooting and should only be used by

qualified engineers.

Bootbase Version: V1.02 | 08/08/2001 15:40:50

RAM: Size = 16384 Kbytes

DRAM Post: Testing: 16384K OK

FLASH: Intel 16M

RAS Version: V3.50(WB.0)b3 | 08/08/2001 16:21:27

Press any key to enter debug mode within 3

seconds.

.................................................

1 2 ... 379 380 381 382 383 384 385 386 387 388 389 ... 464 465

Comments to this Manuals

No comments

ZyXEL P-660HW-T1 User Manual Page 384

Comments to this Manuals

Related products and manuals for Networking ZyXEL P-660HW-T1