ZyXEL 91-005-124003B Datasheet download pdf (Page 34)

G-1000 User’s Guide

34 Chapter 2 Hardware Installation and Initial Setup

Figure 4 G-1000 Top Panel

2.2.1 One 10/100M Ethernet Port

Ethernet 10Base-T/100Base-T networks use Shielded Twisted Pair (STP) cable with RJ-45

connectors that look like a bigger telephone plug with 8 pins. The ETHERNET port is auto-

sensing, so you may use the crossover cable provided or a straight-through Ethernet cable to

connect your G-1000 to a computer/external hub.

Note: When the G-1000 is turned on and properly connected to a computer or a hub,

the ETHN LED on the front panel turns on.

2.2.2 Power Port

Connect the power adapter to the port labeled POWER 12VDC on the top panel of your G-

1000 which then automatically turns on.

Note: The G-1000 will reboot if the supplied power is too low. This is a normal

operation.

Note: To avoid damage to the G-1000, make sure you use the supplied power

adapter. Refer to the Power Adapter Specification appendix for more information.

2.2.3 The RESET Button

Hold this button in for about ten seconds (or until the Link LED turns red) to reboot and

restore your G-1000 to factory default values.

Note: All custom settings will be lost once you reset to the default settings.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 191 192

No comments

ZyXEL 91-005-124003B Datasheet Page 34