ZyXEL GS2200-8/24 User Manual download pdf (Page 117)

Chapter 13 Spanning Tree Protocol

GS2200-8/24 User’s Guide

117

13.6 Configure Multiple Rapid Spanning Tree Protocol

To configure MRSTP, click MRSTP in the Advanced Application > Spanning Tree Protocol

screen. See Multiple RSTP on page 111 for more information on MRSTP.

Figure 73 Advanced Application > Spanning Tree Protocol > MRSTP

The following table describes the labels in this screen.

Table 32 Advanced Application > Spanning Tree Protocol > MRSTP

LABEL DESCRIPTION

Status Click Status to display the MRSTP Status screen (see Figure 72 on page 116).

Tree This is a read only index number of the STP trees.

Active Select this check box to activate an STP tree. Clear this checkbox to disable an STP tree.

Note: You must also activate Multiple Rapid Spanning Tree in the Advanced

Application > Spanning Tree Protocol > Configuration screen to enable

MRSTP on the Switch.

Bridge Priority Bridge priority is used in determining the root switch, root port and designated port. The

switch with the highest priority (lowest numeric value) becomes the STP root switch. If

all switches have the same priority, the switch with the lowest MAC address will then

become the root switch. Select a value from the drop-down list box.

The lower the numeric value you assign, the higher the priority for this bridge.

Bridge Priority determines the root bridge, which in turn determines Hello Time, Max

Age and Forwarding Delay.

1 ... 116 117 118 ... 332

No comments

ZyXEL GS2200-8/24 User Manual Page 117