ZyXEL ES-3124 User Manual download pdf (Page 60)

ES-3124 User’s Guide

58 Chapter 4 The Web Configurator

6 Forgetting the password and/or IP address.

7 Preventing all services from accessing the switch.

8 Changing a service port number but forgetting it.

Note: Be careful not to lock yourself and others out of the switch.

Try using the out-of-band management port before resetting the switch. The

default IP address is 192.168.0.1.

4.7 Resetting the Switch

If you lock yourself (and others) out of the switch, you can try using out-of-band management.

If you still cannot correct the situation or forgot the password, you will need to reload the

factory-default configuration file.

4.7.1 Reload the Configuration File

Uploading the factory-default configuration file replaces the current configuration file with the

factory-default configuration file. This means that you will lose all previous configurations

and the speed of the console port will be reset to the default of 9600bps with 8 data bit, no

parity, one stop bit and flow control set to none. The password will also be reset to “1234” and

the IP address to 192.168.1.1.

To upload the configuration file, do the following:

1 Connect to the console port using a computer with terminal emulation software. See

Section 3.1.1 on page 46 for details.

2 Disconnect and reconnect the switch’s power to begin a session. When you reconnect the

switch’s power, you will see the initial screen.

3 When you see the message “

Press any key to enter Debug Mode within 3

seconds ...

” press any key to enter debug mode.

4 Type

atlc after the “Enter Debug Mode” message.

5 Wait for the “

Starting XMODEM upload” message before activating XMODEM

upload on your terminal.

6 This is an example Xmodem configuration upload using HyperTerminal. Click Transfer,

then Send File to display the following screen.

1 ... 59 60 61 ... 337

No comments

ZyXEL ES-3124 User Manual Page 60