ZyXEL ES-3124 User Manual download pdf (Page 157)

ES-3124 User’s Guide

Chapter 19 Policy Rule 155

The following table describes the labels in this screen.

Table 45 Policy

LABEL DESCRIPTION

Active Select this option to enable the policy.

Name Enter a descriptive name for identification purposes.

Classifier(s) This field displays the active classifier(s) you configure in the Classifier screen.

Select the classifier(s) to which this policy rule applies. To select more than one

classifier, press [SHIFT] and select the choices at the same time.

Parameters

Set the fields below for this policy. You only have to set the field(s) that is related to the action(s) you

configure in the Action field.

General

VLAN ID Specify a VLAN ID number.

Egress Port Type the number of an outgoing port.

Outgoing

packet

format for

Egress port

Select Tag to add the specified VID to packets on the specified outgoing port.

Otherwise, select Untag.

Priority Specify a priority level.

DSCP Specify a DSCP (DiffServ Code Point) number between 0 and 63.

TOS Specify the type of service (TOS) priority level.

Metering You can configure the desired bandwidth available to a traffic flow. Traffic that

exceeds the maximum bandwidth allocated (in cases where the network is

congested) is called out-of-profile traffic.

Bandwidth Specify the bandwidth in kilobit per second (Kbps). Enter a number between 1 and

1000000.

Out-of-

Profile

DSCP

Specify a new DSCP number (between 0 and 63) if you want to replace or remark the

DSCP number for out-of-profile traffic.

Action

Specify the action(s) the switch takes on the associated classified traffic flow.

Forwarding Select No change to forward the packets.

Select Discard the packet to drop the packets.

Select Do not drop the matching frame previously marked for dropping to retain

the frames that were marked to be dropped before.

Priority Select No change to keep the priority setting of the frames.

Select Set the packet’s 802.1 priority to replace the packet’s 802.1 priority field with

the value you set in the Priority field.

Select Send the packet to priority queue to put the packets in the designated

queue.

Select Replace the 802.1 priority field with the IP TOS value to replace the

packet’s 802.1 priority field with the value you set in the TOS field.

1 ... 156 157 158 ... 337

Comments to this Manuals

No comments

ZyXEL ES-3124 User Manual Page 157

Comments to this Manuals

Related products and manuals for Network switches ZyXEL ES-3124