ZyXEL ADSL2+ User Manual download pdf (Page 195)

Prestige 660RU-Tx Series User’s Guide

Chapter 23 SNMP Configuration 194

The following table describes the SNMP configuration parameters.

23.4 SNMP Traps

The Prestige will send traps to the SNMP manager when any one of the following events

occurs:

Table 58 Menu 22 SNMP Configuration

FIELD DESCRIPTION

SNMP:

Get Community Type the Get Community, which is the password for the incoming Get- and

GetNext requests from the management station.

Set Community Type the Set community, which is the password for incoming Set requests from

the management station.

Trusted Host If you enter a trusted host, your Prestige will only respond to SNMP messages

from this address. A blank (default) field means your Prestige will respond to all

SNMP messages it receives, regardless of source.

Trap:

Community Type the trap community, which is the password sent with each trap to the

SNMP manager.

Destination Type the IP address of the station to send your SNMP traps to.

When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm

or ESC to Cancel:” to save your configuration, or press [ESC] at any time to cancel.

Table 59 SNMP Traps

TRAP # TRAP NAME DESCRIPTION

1 coldStart (defined in RFC-1215) A trap is sent after booting (power on).

2 warmStart (defined in RFC-1215) A trap is sent after booting (software reboot).

3 linkDown (defined in RFC-1215) A trap is sent with the port number when any of the

links are down. See the following table.

4 linkUp (defined in RFC-1215) A trap is sent with the port number.

5 authenticationFailure (defined in

RFC-1215)

A trap is sent to the manager when receiving any

SNMP gets or sets requirements with wrong

community (password).

6 whyReboot (defined in ZYXEL-MIB) A trap is sent with the reason of restart before

rebooting when the system is going to restart (warm

start).

6a For intentional reboot : A trap is sent with the message "System reboot by

user!" if reboot is done intentionally, (for example,

download new files, CI command "sys reboot", etc.).

1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 285 286

No comments

ZyXEL ADSL2+ User Manual Page 195