ZyXEL PLA-400 v2 User Manual download pdf (Page 38)

Chapter 4 The ENCRYPT Button

PLA-4xx Series User’s Guide

Figure 18 ENCRYPT Connection Procedure

5 Repeat step 4 in this section for the other powerline device you wish to connect. This

must be done within 120 seconds of pressing the ENCRYPT button on the PLA-4xx.

6 Check the lights on the two powerline devices. The power ( ) and HomePlug ( )

lights should be blinking while the devices are connecting. Several times all lights blink

simultaneously and the HomePlug ( ) light also shows red. Wait for about one minute

while your powerline devices connect.

V If the power ( ) light does not blink when you press ENCRYPT, you have

probably pressed the ENCRYPT button for too long. Try again, pressing the

ENCRYPT button for 1~ 2 seconds.

V If the HomePlug ( ) lights on both powerline devices do not light up, the

powerline devices are not connected. Repeat steps 4 and 5 in this section. If

that doesn’t work, see the Troubleshooting in Section 7.5 on page 71 for

suggestions.

7 To add more powerline devices to your network, press the ENCRYPT button on device

C (shown below) for more than 10 seconds until the power ( ) light flashes.

8 Then repeat steps 4 and 5 in this section using any powerline device (A or B) you have

connected using ENCRYPT and the powerline device you want to connect (C). You

must use the ENCRYPT button on both devices.

press 2 seconds

within 2

minutes

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 91 92

No comments

ZyXEL PLA-400 v2 User Manual Page 38