ZyXEL VSG-1200 User Manual download pdf (Page 38)

VSG-1200 User’s Guide

38 Chapter 2 Hardware Installation and Connection

2.2.1.5 The Reset Button

Use a pointed object to press this button in once to reset the VSG back to the factory defaults.

2.2.2 Front Panel LEDs

The following table describes the LEDs on the front panel. When turned on, all LEDs are

green unless otherwise specified.

2.2.3 Rear Panel

The power socket, the fan and a ventilation hole are located on the rear panel as shown next.

Figure 7 Rear Panel

Note: All your custom configuration including the system usernames and

passwords will be erased.

This will NOT delete the subscriber database or the port-location mappings.

Table 1 Front Panel LEDs

LED STATUS DESCRIPTION

PWR On The VSG is receiving power.

Off The VSG is not receiving power.

ALARM On (Red) There is a hardware failure.

Blink Once (Red) The system is starting up.

Off The system is functioning normally.

LAN or WAN

LK/ACT On The port is connected to an Ethernet device.

Blinking The port is receiving or sending data.

Off The port is not connected to an Ethernet device.

10/100 On The port is operating at 100 Mpbs.

Off The port is operating at 10 Mpbs.

FDX On The port is operating in full-duplex mode.

Off The port is operating in half-duplex mode.

Note: Do NOT block the ventilation hole.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 279 280

No comments

ZyXEL VSG-1200 User Manual Page 38