ZyXEL PLA-407 User Manual download pdf (Page 32)

Chapter 4 The ENCRYPT Button

PLA-407 User’s Guide

4 Press the ENCRYPT button on your second Powerline device for 1~2 seconds. The

power ( ) light will blink as the PLA-407 tries to set up a connection.

Figure 10 ENCRYPT Connection Procedure

Note: The ENCRYPT button’s location varies for each Powerline device.

5 Repeat step 4 in this section for any other Powerline device you wish to connect.

This must be done within 60 seconds of pressing the ENCRYPT button on the

PLA-407.

6 Check the lights on the Powerline devices. The power ( ) and HomePlug ( )

lights should be blinking while the devices are connecting. Several times all lights

blink simultaneously and the HomePlug ( ) light also shows red. Wait for about

one minute while your Powerline devices connect.

If the power ( ) light does not blink when you press ENCRYPT, you have

probably pressed the ENCRYPT button for too long. Try again, pressing the

ENCRYPT button for 1~ 2 seconds.

If the HomePlug ( ) lights on both Powerline devices do not light up, the

Powerline devices are not connected. Repeat steps 4 and 5 in this section. If

that doesn’t work, see the Troubleshooting in Section 9.5 on page 82 for

suggestions.

within 2 minutes

press for

2 seconds

press for

2 seconds

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 93 94

No comments

ZyXEL PLA-407 User Manual Page 32