ZyXEL ZyAIR G-570S User Manual download pdf (Page 69)

ZyXEL G-570S User’s Guide

Chapter 6 Wireless Screens 69

Table 13 Wireless Settings: Bridge

LABEL DESCRIPTION

Operation Mode Select the operating mode from the drop-down list. The options are Access Point,

Wireless Client, Bridge and AP+Repeater.

Note: If you are configuring the device from a computer connected

to the wireless LAN and you change the device to use bridge

mode, you will lose your wireless connection when you click

Apply to save your settings. You must then connect to the

device through the wired network.

SSID The device does not use the SSID with bridge mode. You do not need to configure

it.

Hide SSID The device does not use the SSID with bridge mode. You do not need to configure

this field.

Channel Set the operating frequency/channel depending on your particular region.

Select a channel from the drop-down list box.

Refer to the chapter on wizard setup for more information about channels.

Wireless Mode Select 802.11b only to allow only IEEE 802.11b compliant WLAN devices to

associate with the device.

Select 802.11g only to allow only IEEE 802.11g compliant WLAN devices to

associate with the device.

Select Auto (11g/11b) to allow either IEEE 802.11b or IEEE 802.11g compliant

WLAN devices to associate with the device. The transmission rate of your device

might be reduced.

Local MAC

Address

This is the MAC address of the device.

Remote MAC

Address 1~4

Type the MAC address of the peer device in a valid MAC address format, that is,

six hexadecimal character pairs, for example, 12:34:56:78:9a:bc.

Advanced Settings

Beacon Interval Set the number of milliseconds that should pass between the sending out of

beacons.

Intra-BSS Traffic Intra-BSS traffic is traffic between wireless stations in the same BSS.

Enable Intra-BSS traffic to allow wireless stations connected to the device to

communicate with each other.

Disable Intra-BSS traffic to only allow wireless stations to communicate with the

wired network, not with each other.

DTIM Interval Set the interval for wireless clients in sleep mode to wake up and check for

multicast or broadcast traffic.

The AP includes a Delivery Traffic Indication Message (DTIM) in the beacon to

notify wireless clients in sleep mode that there is a multicast or broadcast packet

awaiting delivery. The interval is a multiple of the beacon interval. For example, if

the beacon interval is 100 milliseconds and the DTIM interval is 2, the AP includes

a DTIM with every second beacon (or every 200 milliseconds).

Radio Enable Turn on the wireless adapter to allow wireless communications between the device

and other IEEE 802.11b and IEEE 802.11g compliant wireless devices. Turn off

the wireless adapter to stop wireless communications between the device and

other IEEE 802.11b and IEEE 802.11g compliant wireless devices.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 161 162

Comments to this Manuals

No comments

ZyXEL ZyAIR G-570S User Manual Page 69

Comments to this Manuals

Related products and manuals for WLAN access points ZyXEL ZyAIR G-570S