ZyXEL Communications Network Router zyxel User Manual download pdf (Page 34)

Chapter 4 Client Mode

WAP3205 User’s Guide

4.3 What You Need to Know

With the exception of the Wireless LAN screens, the LAN, Monitor,

Configuration and Maintenance screens in Client mode are similar to the ones

in Access Point Mode. See Chapter 11 on page 117 through Chapter 12 on page

121 of this User’s Guide.

4.4 Setting your WAP3205 to Client Mode

1 Connect your computer to the LAN port of the WAP3205.

2 The default IP address of the WAP3205 is “192.168.1.2”. In this case, your

computer must have an IP address in the range between “192.168.1.3” and

“192.168.1.254”.

3 Click Start > Run on your computer in Windows. Type “cmd” in the dialog box.

Enter “ipconfig” to show your computer’s IP address. If your computer’s IP

address is not in the correct range then see Appendix C on page 167 for

information on changing your computer’s IP address.

4 After you’ve set your computer’s IP address, open a web browser such as Internet

Explorer and type “http://192.168.1.2” as the web address in your web browser.

5 Enter “1234” (default) as the password and click Login.

6 Type a new password and retype it to confirm, then click Apply. Otherwise, click

Ignore.

7 To set your WAP3205 to Client Mode, on the left of the screen, click

Maintenance > Sys OP Mode and select Client Mode.

Figure 9 Changing to Client mode

Note: You have to log in to the Web Configurator again when you change modes. As

soon as you do, your WAP3205 is already in Client mode.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 259 260

No comments

ZyXEL Communications Network Router zyxel User Manual Page 34