ZyXEL PLA-4xx Series User Manual download pdf (Page 44)

Chapter 4 Powerline Network Setup Tutorial

PLA-4xx Series User’s Guide

Figure 31 An Adapter on Your New Network

6 Go back to step 3 in this section to set the same, new Network Name for all remote

adapters you want to add to your new network.

7 Check you have added the adapters correctly by changing the password for the local

adapter. All adapters with the new Network Name now appear in the list of adapters on

your network. These adapters are now part of your new network.

Figure 32 Adapters on a New Powerline Network

• If you want to access any of your new powerline networks using the PLA-4xx Series

Configuration Utility, change the Network Name on your local adapter to the network

name for the network you want to access. The adapters on that network will then display

in the adapter table, allowing you to select and configure each one.

4.1 Troubleshooting

The LINK ( ) LED (light) should light up on your adapter when it successfully connects to

other adapters on your network. If it does not, try the following measures.

• Make sure the adapter is plugged in to a power socket and the power socket is turned on.

• Check you have entered the correct network name for your network.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 69 70

No comments

ZyXEL PLA-4xx Series User Manual Page 44