ZyXEL ZYWALL IDP 10 User Manual download pdf (Page 9)

ZyWALL IDP 10 Quick Start Guide

Table 2 Rear Panel Power Connection

LABEL DESCRIPTION

WARNING: Using an incorrect power adapter will damage your device!

After you’ve made the connections, use the power cord to connect the power adaptor to a power

source and look at the front panel LEDs.

4.3 The Front Panel LEDs

Figure 5 Front Panel LEDs

The PWR LED turns on when you first connect the power. The SYS LED blinks while performing

system testing and then stays on if the testing is successful. The WAN, LAN and MGMT LEDs turn on

if the corresponding connections are properly made. Refer to the following table for more detailed LED

descriptions.

Table 3 Front Panel LEDs

LED COLOR STATUS DESCRIPTION

Off The ZyWALL IDP is turned off.

Green On The ZyWALL IDP is turned on.

PWR

Red On The power to the ZyWALL IDP is too low.

Off The ZyWALL IDP is not ready or has failed.

On The ZyWALL IDP is ready and running.

SYS Green

Blinking The ZyWALL IDP is restarting.

Off The WAN connection is not ready, or has failed. WAN

10/100

Green On The ZyWALL IDP has a successful 10Mbps WAN

connection.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

No comments

ZyXEL ZYWALL IDP 10 User Manual Page 9