ZyXEL NBG6503 User Manual download pdf (Page 53)

Chapter 6 Easy Mode

NBG6503 User’s Guide

Note: You can enable the Wireless function of your Router by first turning on the switch in

the back panel.

Figure 37 Wireless Security

The following table describes the general wireless LAN labels in this screen.

Table 22 Wireless Security

LABEL DESCRIPTION

Wireless Radio Select the wireless radio to set its security setting.

Wireless

Network Name

(SSID)

(Service Set IDentity) The SSID identifies the Service Set with which a wireless station is

associated. Wireless stations associating to the access point (AP) must have the same SSID.

Enter a descriptive name (up to 32 keyboard characters) for the wireless LAN.

Security mode Select WPA-PSK or WPA2-PSK to add security on this wireless network. The wireless

clients which want to associate to this network must have same wireless security settings as

this device. After you select to use a security, additional options appears in this screen.

Select No Security to allow any client to connect to this network without authentication.

Wireless

password

This field appears when you choose wither WPA-PSK or WPA2-PSK as the security mode.

Type a pre-shared key from 8 to 63 case-sensitive keyboard characters.

Verify password Type the password again to confirm.

Apply Click Apply to save your changes back to the Router.

Cancel Click Cancel to close this screen.

WPS Click this to configure the WPS screen.

You can transfer the wireless settings configured here (Wireless Security screen) to

another wireless device that supports WPS.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 239 240

No comments

ZyXEL NBG6503 User Manual Page 53