ZyXEL PLA470 Series User Manual download pdf (Page 8)

ENGLISH

2 Press the ENCRYPT button at the rear of your powerline

device for 1-2 seconds. The power ( ) light will blink as

the powerline device tries to set up a connection.

• If the power ( ) light does not blink, you have probably

pressed the ENCRYPT button for too long. Try again, press-

ing the ENCRYPT button for 1-2 seconds.

3 Repeat step 2 in this section for the other powerline

device you wish to connect. This must be done within 120

seconds of pressing the ENCRYPT button on the PLA470.

4 Check the lights on the two powerline devices. The power

( ) and HomePlug ( ) lights should be blinking.

Occasionally all lights may blink at the same time and the

HomePlug ( ) light may also show red. Wait for roughly

one minute while your powerline devices connect.

• If the HomePlug ( ) lights on both powerline devices do

not light up, the powerline devices are not connected.

Repeat steps 2 and 3 in this section. If that doesn’t work,

1...2

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 57 58

No comments

ZyXEL PLA470 Series User Manual Page 8