14
3. Power on the rack and wait until you see the Press ENTER to
continue… prompt.
4. Press Enter and the following message is displayed:
Enter Password:
5. Key in the default password 1234, to enter into the CI
command mode.
6. From the ras> prompt type: sys ether type and press Enter to
view the current Ethernet interface setting.
7. To change the Ethernet interface, type: sys ether type and
choose interface 0, 1, or 2 and press Enter.
If the setting number has been changed you must save the new
setting by typing: sys ether save and press Enter.
8. Then type: sys ip disp and press Enter to view the IP address
and other settings.
9. Then type: sys ip addr <IP address> [Subnet Mask] and
press Enter (subnet mask is optional).
10. Then type: sys ip gateway <gateway IP address> and press
Enter to setup the default gateway.
11. Use sys ip save to save IP related settings.
Setting Rack Security
The RS-1612 allows you to control access to the rack and
individual modems.
To set rack security follow the steps below:
1. From the ras> prompt type: nms mask disp and press Enter to
view saved masks.
2. Type one of the following procedures to add or modify a mask:
nms mask add <IP address> modem <slot #’s>
Comments to this Manuals