ZyXEL Dimension ES-2024 User Manual Page 222

  • Download
  • Add to my manuals
  • Print
  • Page
    / 276
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 221
ES-2024 Series User’s Guide
Chapter 32 Configuration Mode Commands 222
Syntax:
igmp-filtering
igmp-filtering profile <name> start-address <ip> end-address <ip>
where
An example is shown next.
Enable IGMP filtering on the switch.
Create an IGMP filtering profile filter1 and specify the multicast IP addresses in the
range
224.255.255.0 to 225.255.255.255 to belong to this profile.
32.4 Enabling STP
Use the spanning-tree or commands to enable and configure STP on the switch.
Syntax:
spanning-tree
spanning-tree priority <0-61440>
spanning-tree hello-time <1-10> maximum-age <6-40> forward-delay <4-30>
spanning-tree <port-list> path-cost <1-65535>
spanning-tree <port-list> priority <0-255>
igmp filtering
= Enables IGMP filtering on the switch
profile <name> =
Specifies a name (up to 32 alphanumeric characters) for this IGMP
profile. If you want to edit an existing IGMP profile enter the existing
profile name followed by
start-address and end-address
parameters.
start-address
<ip>
=
Specifies the starting multicast IP address for a range of multicast IP
addresses that you want to belong to the IGMP filter profile. IP
address in the range 224.0.0.0 to 239.255.255.255 are used for IP
multicasting.
end-address
<ip>
=
Specifies the ending multicast IP address for a range of multicast IP
addresses that you want to belong to the IGMP filter profile. IP
address in the range 224.0.0.0 to 239.255.255.255 are used for IP
multicasting.
sysname(config)# igmp-filtering
sysname(config)# igmp-filtering profile filter1 start-address 224.255.255.0
end-address 225.255.255.255
Page view 221
1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 275 276

Comments to this Manuals

No comments